Mixing Instructions:

Enz-All requires mixing in hot water of 120 degrees to 180 degrees F to activate the catalytic action of the enzymes.

For synthetic carpet:

mix 2 scoops of ENZ-ALL with 1 gallon of hot water stir until blended.

For wool carpet:

mix 1 scoop of ENZ-ALL with 1 gallon of hot water stir until blended.

For restaurant and restroom floors mix: 2 scoops of ENZ-ALL with 1 gallon of hot water stir until blended.

For sheet vinyl and VCT tile mix: 1 scoop of ENZ-ALL with 1 gallon of hot water stir until blended.

Carpet organic soils and oils:

mix ENZ-ALL as directed and apply to carpet using a pump type sprayer or pressure sprayer (not recommended for use in Hydro-Force type units), brush into pile and allow a 5 minute dwell time. Extract using Liquid Formula 90 or similar detergent. For urine problems soak the affected area with diluted ENZ-ALL and allow a ten minute dwell time. Use Urine Contamination Treatment undiluted after the ENZ-ALL has had sufficient dwell time and soak the affected area. Extract using Liquid Formula 90 or similar detergent.

Hard Surfaces organic soils, oil and restroom urine issues:

mix ENZ-ALL as directed in a mop bucket. Mop on to floor, then scrub using a rotary scrubber or small self contained unit. Rinse floor with fresh warm water and pour down grease trap drain.

For restroom tile around urinals and toilets:

mop down, allow a five minute dwell time then rinse mop. Apply Urine Contamination Treatment after cleaning with a mop and allow floor to dry